Emax II operation manual
116
Use the data slider to select whether you will copy primary, secondary or both voices,
then press ENTER.
Caution: If you select both, even though the source preset contains no secondary voices,
you can overwrite double voices during the copying process (step 7).
4. The display says:
Copy: XX
Select Lo Key
...where XX defaults to the lowest note of the lowest voice (whether Pri or Sec).
Press the lowest key of the range you want to copy, or to quickly select the lowest note
of the available voices, use the data slider. While selecting the low key, the lower display
line will show the voice number and its original pitch. When the display shows the
desired low key, press ENTER.
The display now asks you to choose the Hi Key:
Copy: XX to YY
Select Hi Key
...where YY defaults to the highest note of the previously selected voice.
Press the highest key of the range you want to copy or to quickly select the highest note
of the available voices, use the data slider. After selecting the range to copy, press
ENTER.
5. The display asks:
CopyVoiceTo PXX
Select A Preset
... where PXX defaults to the current preset.
6. Select the destination preset to which you want to copy the voice(s), then press
ENTER.
PRESET DEFINITION
Copy Voice
To Next Page
Loading...