Emax II operation manual
117
If you select an empty preset, upon pressing ENTER you will be given a chance to
rename the preset that the Emax II just created for you. Rename as described in PRESET
MANAGEMENT 6.
After renaming is complete, press ENTER.
7. The display now shows:
Copy Voice To
Pri or Sec: XXX
...where XXX defaults to your previous selection in step 2 (note: if in step 2 you selected
both, then the Emax II will automatically go to step 9). This step allows you to copy
primary voice(s) to secondary locations and visa versa.
8. Use the data slider to select whether you will copy the voice(s) to a primary or
secondary location, then press ENTER.
9. The display now says:
Lo:XX
Select New LoKey
...where XX defaults to the previously-selected low key.
Press the low key of the desired range in the destination preset. The lower display line
will show the voice number and original pitch in the destination preset. Attempting to
place the low note in such a way that the range cannot be assigned produces an “Illegal
Asgnment” display.
10. After specifying the range’s low note, press ENTER. The display will warn you if this
assignment either modifies the existing assignment or erases (overwrites) any existing
voice(s). If this is okay, press YES to copy and return to the module identifier. Otherwise,
press NO to interrupt the copying process and return to the module identifier.
PRESET DEFINITION
Copy Voice
To Next Page
Loading...