Emax II operation manual
118
PRESET DEFINITION 2 EDIT ASSIGNMENT
Use this function to change the assignment of a voice within a preset.
1. Activate PRESET DEFINITION 2. The display says:
Edit Pri or Sec
Voice: XXX
...where XXX is either Pri or Sec. Use the data slider to select whether you will edit the
primary or secondary voice, then press ENTER. If there are only primary or secondary
voices, Emax II will automatically go to step 2.
2. The display now says:
Edit: XX
Select A Voice
...where XX defaults to the lowest note of the lowest voice (whether Pri or Sec).
Press a key in the range of the voice that you want to edit, or to quickly select the voice,
use the data slider. While selecting the voice, the lower display line will show the voice
number and its original pitch. After selecting the voice to edit, press ENTER.
Edit Assignment
Tip
Ring
Tip
Ring
Tip
Ring
Tip
Ring
Tip Tip
Ring
SUB B SUB C MAIN
RL RL RL
R Bus
L Bus
Emax II Output Section
Tip
Ring
Tip
Ring
SUB A
RL
The Sub A, B, and C jacks can be used as effect returns to the Main Outputs.
▼
When editing stereo
voices, make sure that
the keyboard assign-
ments of the primary
and secondary voices
match to prevent unde-
sirable results.
To Next Page
Loading...