E-Mu EMAX II - Erase Voice

Emax II operation manual
120
PRESET DEFINITION 3 ERASE VOICE(S)
Use this function to erase a voice(s).
1. Activate PRESET DEFINITION 3. The display shows:
Erase Pri, Sec
or Both: XXX
... where XXX is either Pri, Sec or Both.
Use the data slider to select whether you will erase the primary, secondary, both voice(s),
then press ENTER. If there are only primary or secondary voices, Emax II will
automatically go to step 2.
2. The display says:
Lo:XX
Select Lo Key
...where XX defaults to the lowest note of the lowest voice (whether Pri or Sec).
3. Press the lowest key of the range you want to erase, or to quickly select the lowest note
of the available voices, use the data slider. While selecting the low key, the lower display
line will show the voice number and its original pitch. When the display shows the
desired low key, press ENTER. The display now asks you to choose the Hi Key:
Lo:XX Hi:YY
Select Hi Key
...where YY defaults to the highest note of the previously selected voice.
4. Press the highest key of the range you want to erase or to quickly select the highest note
of the available voices, use the data slider. After selecting the range to erase, press
ENTER.
5. The display will warn you if this assignment either modifies the existing assignment
or erases (overwrites) any existing voice(s). If this is okay, press YES to erase and return
to the module identifier. Otherwise, press NO to interrupt the erasing process and return
to the module identifier.
PRESET DEFINITION
Erase Voice