Emax II operation manual
122
PRESET DEFINITION
2. Now the display shows:
Hi:XX Stereo:Off
Select Hi Voice
...where XX defaults to the highest note of the previously selected voice. Press the highest
key of the highest voice that you want to put into or out of stereo voice mode, or to
quickly select the voice, use the data slider. After selecting the high voice, press ENTER.
3. Now you see...
Stereo Voice:XX
Select on/off
...where XX is either on or off. Use the ON and OFF buttons to select whether stereo voice
is on or off, then press ENTER. The Emax II will inform you that secondary parameters
will be altered if you select stereo voice on. If that’s okay, press YES; otherwise, press
NO to abort and the Emax II will return to the module identifier.
Note: Stereo Voice mode automatically pans the primary and secondary voices to
opposite sides. If the stereo pan position (DYNAMIC PROCESSING 19) is altered, the
primary and secondary voice pan positions will move in opposing directions. In the
center position, the signal will be monophonic.
Stereo Voice
■
Using Chorus mode
with stereo voices
produces a beautiful
stereo chorus effect.
To Next Page
Loading...