Emax II operation manual
125
You now may select from the following choices:
■ XFade Off = There is no crossfading between the primary and secondary voices.
■ Velocity XFade = One voice will become louder as you play more forcefully; the other
voice will become softer.
■ Velocity XSwitch = If you strike a key with more force than the mid-point of the
velocity range, one voice will play; if you strike a key with less force than the mid-point
of the velocity range, the other voice will play.
■ Positional XFade = As you play from low to high over the current voice, one voice
will fade out as the other voice fades in. This is a useful technique for maintaining an even
tone quality over the keyboard when using multi-samples.
■ Realtime XFade = Crossfading occurs not according to keyboard velocity, but
according to the real time controller that has been assigned. (See Preset Definition 9)
■ Realtime XSwitch = Crossfading occurs not according to keyboard velocity, but
according to the real time footswitch.
4. If you choose any option except for Positional XFade, the display says:
Pri or Sec Voice
Equals Hard: Sec
Use the data slider to select whether the primary or secondary voice will:
● Fade in when the keyboard is played forcefully (Velocity XFade);
● Switch in when the keyboard is played forcefully (Velocity XSwitch);
● Fade in according to the real time control wheel (Realtime XFade); or
● Switch in according to the real time footswitch (Realtime XSwitch).
If you choose Positional Crossfade, the display will say:
Pri or Sec Voice
On Top: Sec
The selected voice will become more prominent as you play higher on the keyboard, and
the other voice will become less prominent.
5. After making your selection, press ENTER.
PRESET DEFINITION
Crossfade/Cross-switch
To Next Page
Loading...