Emax II operation manual
132
16. The next arpeggiator option is Glissando. The display says:
Glissando: off
Select on/off
Use the ON and OFF buttons to select whether Glissando is on or off. Glissando will play
every chromatic step between the notes played, including extensions.
17. Last, but not least comes the range adjustment. The display says:
Range: A-1 to C7
Select Lo Key
This is the default setting and indicates that arpeggiation will occur in the range of A-1
to C7 (the full MIDI range of notes). Play the key that corresponds to the lowest note in
the range you want arpeggiated (or use the data slider), then press the RIGHT ARROW
key. The cursor will move to the second note in the display, which now says:
Range: XX to C7
Select Hi Key
...where XX is the note you just selected. Now play the note that corresponds to the
highest note in the range you want arpeggiated (or use the data slider).
The display will confirm your choice; press ENTER to jump back to the module
identifier, otherwise press the right arrow cursor button to continue the setup. Note: The
Emax II will not let you choose a lower note higher than the currently selected upper
note.
Now that the arpeggiation setup is complete, press ENTER to jump back to the module
identifier. Or, you can use the cursor keys to go back and change previously selected
parameters.
Arpeggiator
PRESET DEFINITION
To Next Page
Loading...