Emax II operation manual
134
4. The next display says:
MIDI Mode: omni
Use Data Slider
Use the data slider to change MIDI mode as follows:
● OMNI accepts MIDI information coming in on any channel.
● POLY accepts MIDI information only on the basic channel.
After making your selection, press ENTER to jump back to the module identifier,
otherwise press the right arrow cursor button to continue the setup.
5. The next display says:
Preset Chng: on
Select on/off
MIDI also carries program (preset) change information from one synthesizer to another.
Press ON if you want the Emax II to send and receive program changes, or OFF if you
want to select Emax II presets independently of other MIDI instruments. To jump back
to the module identifier press ENTER, otherwise press the right arrow cursor key to
continue the setup.
Note: There is no specific standard between manufacturers regarding what program
(“patch”) will occur on “slave” synthesizers when a particular program is selected on the
“master” synthesizer. Some instruments number programs sequentially, while others
arrange programs in “banks” (e.g., A1, A2, A3,...B1, B2, etc.).
6. The next display says:
Start/Stop: off
Select on/off
When connected in a MIDI system, you may or may not want the Emax II to respond to
“start and stop sequence” commands from other instruments, preferring instead to start
and stop sequences from the Emax II. Press ON if you want the Emax II sequences to start
and stop under control of another MIDI instrument; press OFF if you want to start and
stop sequences exclusively from the Emax II.
MIDI
PRESET DEFINITION
To Next Page
Loading...