Emax II operation manual
136
To return to the module identifier press ENTER, otherwise press the right arrow cursor
button to continue the setup.
10. The next screen says:
Rt Wheel <-> 01
[00-33] / Slider
You may now assign a controller number to the Right Wheel in exactly the same manner
as you assigned a controller number to the Left Wheel in step 9. To return to the module
identifier press ENTER, otherwise press the right arrow cursor button to continue the
setup.
11. The next display shows:
Pedal <-> off
[00-33] / Slider
You can now assign a controller number to the Pedal in exactly the same manner as you
assigned a controller number to the Left Wheel in step 9. To return to the module
identifier press ENTER, otherwise press the right arrow cursor button to continue the
setup.
12. We’re not done yet. The next displays says:
Pressure <-> chp
[00-33] / Slider
You may now assign a controller number (chp = the MIDI standard for monophonic
pressure) to the keyboard’s pressure (aftertouch) function in exactly the same manner
as you assigned a controller number to the Left Wheel in step 9. To return to the module
identifier press ENTER, otherwise press the right arrow cursor button to continue the
setup.
13. The next display says:
MIDI A <-> pwh
[00-33] / Slider
MIDI
PRESET DEFINITION
■
The Emax II key-
board does not gener-
ate aftertouch (pres-
sure). The Pressure
function is used to
route incoming pres-
sure data when re-
ceived over MIDI.
To Next Page
Loading...