Emax II operation manual
138
PRESET DEFINITION 8 PITCH BEND RANGE
This function adjust the pitch wheel range from +0 (off) to ±4 semitones.
1. Activate PRESET DEFINITION 8. The display says:
Pitchbend Range:
±X semitones
...where X is a number between 0 and 4.
2. Select the desired number with the data slider, numeric keypad. Press ENTER after
making your choice, and the Emax II will return to the module identifier.
PRESET DEFINITION 9 REAL-TIME CONTROLS
Real-time functions are designed for fast, easy selection while playing live. Each
preset can have its own unique set of pre-programmed realtime functions.
1. Activate PRESET DEFINITION 9.
2. The display shows each control source as a pair of numbers. The first digit of each pair
represents the control source (e.g., wheel, pedal, etc.), the second digit the control
source’s destination (filter cutoff, pitch, etc.). Select the control source to which you want
to assign a destination by keying in the appropriate control source number:
1: Left wheel (center detent, spring return type)
2: Right wheel (continuously variable type)
3: Pressure (sent from an external MIDI keyboard that has pressure sensitivity)
4: Pedal A/D (plugs into rear panel PEDAL jack)
5: MIDI control A
6: MIDI control B
7: Footswitch 1 (plugs into rear panel Foot Switch 1 jack)
8: Footswitch 2 (plugs into rear panel Foot Switch 2 jack)
Each of destinations 0-9 printed in the upper part of the right-hand column located in the
Preset Definition module can be controlled by control sources 1 through 4. Each
destination can be controlled by only one of the 4 Emax II controllers.
PRESET DEFINITION
Pitch Bend Range
1:1 2:4 3:0 4:0
5:3 6:0 7:3 8:2
■
The first number of
each group represents
the control source and
the second number rep-
resents the destination.
To Next Page
Loading...