Emax II operation manual
144
• Destination: (Footswitch) 5 X-SWITCH
For footswitch controlled switching between the primary and secondary preset voices,
first select the footswitch then select 5. Pressing the footswitch will alternate between the
two samples.
Note: This function must also be enabled under Pre▲❅t Definition function 5 (Velocity
XFade).
l Destination: (Footswitch) 6 ADVANCE PRESET
To advance via footswitch from one preset to the next higher numbered preset (i.e., from
Preset 01 to Preset 02), first select the footswitch then select 6. Press the footswitch
momentarily to advance to the next preset. Advancing past the highest-numbered preset
resets the Emax II to the lowest numbered preset.
Note: If you advance to a preset which does not have this destination assigned to one of
the footswitches, you will not be able to advance out of that preset.
Hint: Use this function to return the display to the preset identifier mode when the
sequencer is playing, enabling you to play different presets while listening to the
sequencer.
Special Note: The Emax II is designed to work with two types of footswitches. If your
footswitch seems to work backwards, refer to Recalibrate, l
ocated under
Special in the Master
module.
PRESET DEFINITION 0STACK PRESETS
This function allows you to stack up to four presets on each key of the keyboard.
In Stack Preset mode, the current preset can be “Stacked” with up to three adjacent
presets above it. For instance; if the current preset is 01, then presets 02, 03, and 04 may
be stacked up so that one key will sound all four presets. The polyphony of the Emax II
will vary according to the voice architecture of each preset in the stack.
1. Select the current preset; this preset will contain the stack information.
2. Activate PRESET DEFINITION 0.
T
he display says:
PRESET DEFINITION
Stack Presets
To Next Page
Loading...