Emax II operation manual
149
DYNAMIC PROCESSING 00 CHANGE CURRENT
VOICE(S)
This function lets you change the current voice assignment.
1. Activate DYNAMIC PROCESSING 00. The display will say:
Edit Pri, Sec or
Both Voices: XXX
...where XXX is either Pri, Sec or Both.
2. Use the data slider to select whether the primary , secondary, or both voices are to be
included in the current voice group, then press ENTER.
3. You may select the entire keyboard by pressing the DYNAMIC PROCESSING or the
ENTER button twice in sucession.
4. If the preset contains only primary or secondary voices, the Emax II is smart enough
to bypass the first screen and say:
Lo: XX
Select Lo Voice
...where XX defaults to the lowest note of the lowest voice. Press a key in the range of the
low voice that you want to process, or to quickly select the low voice, use the data slider.
While selecting the low voice, the lower display line will show the voice number, its
original pitch. After selecting the low voice, press ENTER.
5. The display now says:
Lo:XX -> Hi:HH
Select Hi Voice
... where XX is the previously-selected low note and HH is the highest note of the voice
that contains the lowest note. Press a key in the range of the high voice that you want to
process, or to quickly select the high voice, use the data slider. After selecting the high
voice, press ENTER to complete the current voice selection and return to the module
identifier.
DYNAMIC PROCESSING
Change Current Voice
To Next Page
Loading...