Emax II operation manual
158
3. After making your selections, press ENTER to return to the module identifier.
DYNAMIC PROCESSING 16 LFO TO
(VIBRATO, TREMOLO,
FILTER Fc, PANNING)
The LFO can modulate four different parameters—pitch, amplitude, filter cutoff
frequency, and stereo placement. The modulation depth (index) is variable from
00 to 15.
Application: LFO modulating the pitch provides vibrato effects; LFO modulating VCA
provides tremolo effects (as used for years in guitar amplifiers—attention surf music
fans); LFO modulating filter provides timbre modulation effects; LFO modulating
panning sweeps the sound back and forth between the left and right channels (i.e.,
spatial modulation).
1. Activate DYNAMIC PROCESSING 16. The display will say:
Vib Trem Fc Pan
XX XX XX XX
2. Select the desired parameter for adjustment with the cursor buttons, then use the data
slider or increment buttons to change the parameter value as desired:
■ Vibrato: Determines the extent to which the LFO modulates pitch. Range is from 00
to 15, with higher values giving more modulation.
■ Tremolo: Determines the extent to which the LFO modulates the VCA. Range is from
00 to 15, with higher values giving more modulation.
■ Fc (Filter Cutoff): Determines the extent to which the LFO modulates the filter cutoff
frequency. Range is from 00 to 15, with higher values giving more modulation.
■ Pan: Determines the extent to which the LFO modulates the stereo placement. Range
is from 00 to 15, with higher values giving more drastic motion between the left and right
channels.
3. After making your selections, press ENTER to return to the module identifier.
DYNAMIC PROCESSING
LFO Routing
To Next Page
Loading...