Emax II operation manual
170
The display says:
Load Seq from XX
XX Name of Bank
...where “XX” is the bank number and “Name of Bank” is the name of the bank.
Use the data slider or the increment/decrement buttons to select the bank you want to
load the sequence from, then press ENTER. The display now says:
Load SXX
Select Sequence
...where XX is a two-digit number. Use the data slider or numeric keypad to select the
sequence you want to load, then press ENTER.
2. The display now says:
Load SXX To SYY
Select Sequence
...where XX is the sequence number selected in the previous step (source sequence), and
YY is the sequence number the loaded sequence will have in the Emax II’s bank
(destination sequence; this defaults to the first available empty sequence). Use the slider
or numeric keypad to select one of the 50 sequences in the Emax II.
3. Press ENTER after choosing the desired sequence, and the sequence will be loaded.
If you haven chosen to load into a non-empty sequence, the display will prompt you
with:
Load SXX to SYY
Overwrite Y/N
Press YES to overwrite, NO to select a different destination sequence.
SEQUENCER MANAGE
Load Sequence
To Next Page
Loading...