E-Mu EMAX II - Erase Sequence

Emax II operation manual
171
4. Once the sequence has been loaded, you have the option to rename it:
Rename Sequence
SXX (seq. name)
Press ENTER if you don’t want to rename; this returns you to the module identifier.
Otherwise, name the sequence as described in SEQUENCER MANAGE 6.
SEQUENCER MANAGE 4 ERASE SEQUENCE
This function erases a sequence in the Emax II memory. It does not erase a
sequence from disk. To erase a sequence from disk, you must first load the
disk, erase the sequence, then save the bank to disk (PRESET MANAGEMENT
2).
1. With the Sequencer Manage module active, select 4.
2. The display says:
Erase SXX
Select Sequence
...where XX is a two-digit sequence number. Use the slider, or numeric keypad to select
the sequences in memory. After selecting the sequence to be erased, press ENTER. The
display says:
Erase SXX
Are You Sure Y/N
3. Press YES to erase and return to the module identifier, or if you change your mind,
press NO (Emax II still returns to the module identifier).
SEQUENCER MANAGE
Erase Sequence