E-Mu EMAX II - Erase Track; Bounce Track

Emax II operation manual
176
SEQUENCER SETUP 4 ERASE TRACK
Okay, so that 32nd note bass track wasn’t so cool after all. Here’s how to get rid
of it.
1. Select the current sequence whose track you want to erase.
2. With the Sequencer Setup module active, select 4. The display shows:
Erase Track XX
Select Track
...where XX is the track number that’s about to be erased. Select the track to be erased
with the data slider or keypad; the display’s lower line will show its associated preset.
Press ENTER. Emax II, which always does what it can to help you prevent embarrassing
mistakes, asks “Are You Sure Y/N.” If yes, press YES, otherwise press NO.
SEQUENCER SETUP 5 BOUNCE TRACK
You may bounce a track to any other sequencer track, or even bounce several
tracks, one at a time, into a composite track
1. Select the current sequence whose track you want to bounce.
2. With the Sequencer Setup module active, select 5. The display shows:
Bnce TXX
Select Track
...where XX is the track number that’s about to be bounced (source track). Select the
source track (data slider, increment buttons or keypad), then press ENTER.
3. The display now shows:
Bnce TXX To TYY
Select Track
SEQUENCER SETUP
Erase Track