Emax II operation manual
178
SEQUENCER SETUP
Supermode
The display shows:
Super Mode: off
Select on/off
Press ON to enable SuperMode. Remember to make sure SuperMode is off (press
OFF button) when you’ve finished with SuperMode. Emax II will now respond to
multiple MIDI channels and route them to the preset specified in the map.
SUPER MODE DOWNLOAD
1. Check that the Emax II MIDI IN connects to the external sequencer’s MIDI OUT.
2. Activate SEQUENCER MANAGE 2 and select MIDI as the clock source.
3. Activate SEQUENCER SELECT and select the current sequence into which you will
download the tracks.
4. Activate the SEQUENCER SETUP module and select 6.
The display shows:
Super Mode: off
Select on/off
Press ON to enable SuperMode. Remember to make sure SuperMode is off (press OFF
button) when you’ve finished downloading!
5. Select the tracks you want to download and put them in record mode according to the
instructions in SEQUENCER SETUP 1. For example, if you want to download five
tracks (MIDI channels), place the five Emax II tracks corresponding to each of the MIDI
channels into record.
6. Press RECORD then PLAY on Emax II, then put your fancy sequencer into Play mode.
The sequencer will start Emax II and send its MIDI data through the MIDI OUT into the
Emax II MIDI IN. Emax II should be set for MIDI clock in. Either stop Emax II manually
to terminate the downloading process, or stop the sequencer.
7. Assign the tracks to presets as desired—preset MIDI channel information is ignored—
(SEQUENCER SETUP 2), change to Internal Clock (SEQUENCER MANAGE 2), and
To Next Page
Loading...