Emax II operation manual
210
SPECTRUM SYNTH OPTIONS MENU
There are ten options listed in the spectrum synthesis menu. Each of these options covers
a specific function or group of functions, and some contain sub-menus and functions.
When a menu option contains multiple functions, answering YES to the prompt “ ... ?
Y /N “ will execute the function and then take you to the next level of operation.
Answering NO to the prompt takes you to the next option in the sub-menu. The menu
options are as follows:
1. FREQUENCY SPECTRUM
In this menu, spectrums may be drawn, edited, copied, and placed.
DRAW
a Spectrum
(Use for quick and easy creation of spectrums)
A. Press #1 on the keypad to access the Frequency Spectrum menu options.
B. Use the slider to select the number of the spectrum you wish to draw. Press ENTER.
C. Press YES to start the drawing countdown. You will see the display countdown
5...4...3...2...1... When the countdown finishes, the drawing process starts. The
cursor position automatically moves from left to right - each position of the cursor
denoting one partial. By raising and lowering the slider as the cursor moves across the
screen, you can draw the amplitude of each of the twenty four partials. The bar graph
displays the relative amplitude of the partials.
D. Press NO three times to return to the Additive Options menu.
EDIT
a Spectrum
(Use for precise definition of spectrums and partial amplitudes)
A. Press #1 on the keypad to access the Frequency Spectrum menu options.
B. Use the slider to select the number of the spectrum you wish to edit. Press ENTER.
C. Press NO to get to the spectrum EDIT screen. Press YES to edit.
D. Use the slider to enter the amplitude of the partials. Amplitude is shown inpercen-
tages on the right hand side of the screen.
E. Use the cursor (<- ->) buttons to move from partial to partial.
F. Press ENTER , then NO twice to return to the Synth Options menu.
SPECTRUM SYNTHESIS
Frequency Spectrum
To Next Page
Loading...