Emax II operation manual
212
C. Press YES to start the drawing countdown. You will see the display countdown
5...4...3...2...1... When the countdown finishes, the drawing process starts. The
cursor position automatically moves from left to right - each position of the cursor
denoting one partial. By raising and lowering the slider as the cursor moves across the
screen, you can draw the amplitude of each of the twenty four partials. The bar graph
displays the relative amplitude of the partials.
D. Press NO three times to return to the Synth Options menu.
EDIT
a Time Slice
(Use for precise definition of time slices and partial amplitudes)
A. Press #2 on the keypad to access the Time Slice menu options.
B. Use the slider to select the number of the time slice you wish to edit. Press ENTER.
C. Press NO to get to the time slice EDIT screen. Press YES to edit.
D. Use the slider to enter the amplitude of the partials. Amplitude is shown inpercen-
tages on the right hand side of the screen.
E. Use the cursor (<- ->) buttons to move from partial to partial.
F. Press ENTER , then NO twice to return to the Additive Options menu.
COPY
a Time Slice
(Use for placing the same time slice at two different locations, or for creating a duplicate
time slice which can then be modified)
A. Press #2 on the keypad to access the Time Slice menu options.
B. Use the slider to select the number of the time slice you wish to copy. Press ENTER.
C. Press NO two times to get to the time slice COPY screen.
D. Press YES to copy. The display reads “Copy TS01 to TS01...”.
E. Use the slider to select the number of the time slice that you wish to copy to.
F. Press ENTER, then NO to return to the Synth Options menu, or YES to make another
copy.
SPECTRUM SYNTHESIS
Time Slices
To Next Page
Loading...