Emax II operation manual
213
T SLICE -> SP
(Use for moving a time slice to a spectrum location)
A. Press #2 on the keypad to access the Time Slice menu options.
B. Use the slider to select the number of the time slice you wish to move. Press ENTER.
C. Press NO three times to get to the MOVE screen.
D. Press YES. The display will read “MoveTS01 to: SP01...”.
E. Use the slider to select the number of the spectrum where you want to move the time
slice.
F. Press ENTER to execute the move.
Note: After executing a function in the Time Slice options menu, it is not necessary to exit
the menu before accessing another function. For example, you may DRAW a time slice,
then EDIT, COPY, and MOVE it before returning to the Synth Options menu.
3. AMPLITUDE CONTOUR
In this menu you may draw, edit, and copy the amplitude envelope of specific partials.
DRAW
a partial’s Amplitude Contour
(Use for quick and easy creation of the volume envelope of a specific partial)
A. Press #3 on the keypad to access the Amplitude Contour menu options.
B. Use the slider to select the number of the partial whose amplitude contour you wish
todraw. Press ENTER.
C. Press YES to start the drawing countdown. You will see the display countdown
5...4...3...2...1... When the countdown finishes, the drawing process starts. The cursor
position automatically moves from left to right - each position of the cursor denoting one
time slice. By raising and lowering the slider as the cursor moves across the screen, you
can draw the amplitude of the partial at each of the 24 time slice locations. The bar graph
displays the relative amplitude of the partial at each time slice.
D. Press NO twice to return to the Synth Options menu.
EDIT
a partial’s Amplitude Contour
(Use for precise definition of partial amplitudes)
A. Press #3 on the keypad to access the Amplitude Contour menu options.
B. Use the slider to select the number of the partial whose amplitude contour you wish
to edit. Press ENTER.
SPECTRUM SYNTHESIS
Amplitude Contour
To Next Page
Loading...