Emax II operation manual
215
can draw the pitch of the partial at each of the 24 time slice locations. The bar graph
displays the relative pitch of the partial at each time slice, from plus 1 semitone to minus
1 semitone.
D. Press NO twice to return to the Synth Options menu.
EDIT
a partial’s Pitch Contour
(Use for precise definition of partial pitches)
A. Press #4 on the keypad to access the Pitch Contour menu options.
B. Use the slider to select the number of the partial whose pitch contour you wish to edit.
Press ENTER.
C. Press NO to get to the pitch contour EDIT screen. Press YES to edit.
D. Use the slider to enter the pitch of the partial at each time slice. Pitch is shown incents
on the right hand side of the screen, from -99 cents to +98 cents.
E. Use the cursor (<- ->) buttons to move from time slice to time slice.
F. Press ENTER , then NO twice to return to the Synth Options menu.
COPY
a partial’s Pitch Contour
(Use for copying the pitch contour of a partial to one or more partials.)
A. Press #4 on the keypad to access the Pitch Contour menu options.
B. Use the slider to select the number of the partial whose pitch contour you wish to copy.
Press ENTER.
C. Press NO two times to get to the pitch contour COPY screen.
D. Press YES to copy. The display reads “Copy PC01 to PC01...”.
E. Use the slider to select the number of the partial that you wish to copy the pitch contour
to.
F. Press ENTER to execute the copy, then YES to make another, or NO to return to the
Synth Options menu.
Note: After executing a function in the Pitch Contour options menu, it is not necessary
to exit the menu before accessing another function. For example, you may DRAW a pitch
contour, then EDIT and COPY it before returning to the Synth Options menu.
SPECTRUM SYNTHESIS
Pitch Contour
To Next Page
Loading...