Emax II operation manual
218
9. ERASE PARAMETERS
The following parameters may be erased:
None
Backup #1
Backup #2
Backup #3
Current Parameters
Spectrums (entire palette)
All! (everything listed above)
To
ERASE
parameters:
A. Press #9 on the keypad to access the Erase screens.
B. Use the slider to access the erase option you desire.
C. Press ENTER then YES to execute the erase and return to the Synth Options menu.
0. SYNTHESIZE!
Use to generate the sound that you have defined.
A. Press #0 on the keypad to access the Synthesize! menu.
B. Use the slider to select “smooth” or “stepped”.
C. Press ENTER to begin synthesizing.
D. When Emax has finished its calculations, play your sound!
E. Press ENTER again to return to the Synth Options menu.
Note: After returning to the Synth Options menu, the sound will no longer be active on
the keyboard. The only time you can hear your sound while in the Synth Options menu
is immediately after it has been synthesized.
Also Note: There are two modes of synthesis - “Smooth” and “Stepped”. “Smooth” will
produce a very gradual tonal change from time slice to time slice. “Stepped” will result
in more abrupt tonal changes, as each time slice plays for exactly one twenty-fourth of
the sound and then jumps to the next time slice. A sound may be synthesized in one
mode and then synthesized again in the other mode. Use the mode that best suits the
type of sound you are trying to create.
SPECTRUM SYNTHESIS
Erase Params
To Next Page
Loading...