Emax II operation manual
21
GUIDED TOURS
GUIDED TOUR #1:
MEET THE EMAX II
Welcome to the Guided Tours! If you have just met Emax II for the first time, follow these
tours until you complete the Guided Tours section. This will get you “up and running”
on the Emax II in the fastest possible time. Also, you’ll learn some tricks in this section
that will come in handy as you play some more with the Emax II.
This tour covers how to...
● Get ready for the tours
● Load a bank from the hard disk
● Select different presets within the bank
● Load a floppy disk
● Tune the Emax II to other instruments
● Transpose the keyboard
...and also discusses Emax II’s “modular” design philosophy.
HOW TO USE THE GUIDED TOURS
Please follow all steps exactly as given. For example, if we ask you to load the Arco
Strings disk, even if you would really rather hear something else load in the strings—
several sections of the tour will refer to specific sounds on that disk.
Occasionally during a tour you will be told to refer to something like PRESET
DEFINITION 4, SAMPLE 2, or some other name. This means that you will find more
information in the specified section of the manual’s reference section. For example,
PRESET DEFINITION 4 indicates that the information is in the preset definition chapter
under section 4; SAMPLE 2 indicates that the information is in the sample chapter under
section 2.
GETTING READY FOR THE GUIDED TOURS
Have you sent in your warranty card yet? Listen, we’re not kidding! Send it in!!
Okay. Now you can proceed.
Set up the Emax II as described in the Introduction under Instant Gratification. After
completing step 5, return to this section.
LOADING FLOPPY DISKS
So far, so good...now it’s time to move on.
1. Press the button labeled DRIVE SELECT and use the data slider to select, SCSI 0:
Floppy.
Guided Tour #1
To Next Page
Loading...