Emax II operation manualPrecautions
RADIO and TELEVISION INTERFERENCE
The equipment described in this manual generates and uses radio-frequency energy. If it is not
installed and used properly-- that is, in strict accordance with our instructions - it may cause
interference with radio and television reception.
This equipment has been tested and complies with the limits for a Class A computing device in
accordance with the specifications in Subpart J of Part 15 of the FCC rules. These rules are designed
to provide reasonable protection against such interference in a residential installation. However,
there is no guarantee that the interference will not occur in a particular installation, especially if
a "rabbit ear" television antenna is used.
If the Emax II does cause interference to radio or television reception, you can try to correct the
interference by using one or more of the following measures:
■ Turn the television or radio antenna until the interference stops.
■ Move the Emax II to one side or the other of the television or radio.
■ Move the Emax II farther away from the television or radio.
■ Plug the Emax II into an outlet on a different circuit than the television or radio.
■ Consider installing a rooftop antenna with a coaxial lead-in between the antenna and
television set.
7. This product, in combination with an amplifier and headphones and speakers, may be capable
of producing sound levels that could cause permanant hearing loss. Do not operate for a long
period of time at a high volume level or at a level that is uncomfortable. If you experience any
hearing loss or ringing in the ears, consult an audiologist.
8. This Emax II may be equipped with a polarized line plug (one blade wider that the other). This
is a safety feature. If you are unable to insert this plug into the outlet, do not defeat the safety
purpose of the plug. Contact an electrician to replace your obsolete outlet.
9. The power supply cord of the Emax II should be unplugged from the outlet when left unused
for a long period of time.
10. Care should be taken so that objects do not fall and liquids are not spilled into the enclosure
of the Emax II through openings.
11. The product should be serviced by qualified service personnel when:
A. The power supply cord has been damaged; or
B. Objects have fallen, or liquid has been spilled into the product; or
C. The product has been exposed to rain; or
D. The product does not appear to operate normally or exhibits a marked change in
performance; or
E. The product has been dropped or the enclosure damaged.
12.All servicing should be referred to qualified service personnel.
SAVE THESE INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER OR BACK
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
To Next Page
Loading...