Emax II operation manual
50
FUNCTION DRIVE SELECT
This function selects which storage device will be used when loading or saving. The
Emax II, in addition to its floppy disk drive, may have an internal hard disk or up to
seven external SCSI devices (hard disks, etc.) may be attached to the SCSI port located
on the back panel. Drive Select, selects which storage device will be used.
1. Press DRIVE SELECT. The display says:
SCSI 0: Floppy
Use the data slider to scroll through the SCSI numbers (0-7). If you have a formatted hard
disk connected, the display will show the name of the hard drive and the amount of
memory remaining.
Simply select the desired drive and press ENTER to select a particular drive.
FUNCTION LOAD BANK
A disk stores presets, voices, and sequences. Load Bank loads all data on the disk
into the Emax II.
When the machine is first turned on, a sound bank is not automatically loaded. Any time
you want a bank of new sounds, you must use Load Bank to transfer disk data into the
Emax II.
1. Insert the disk to be loaded into the drive (if applicable).
2. Press LOAD BANK. The display says:
Hard Disk Floppy Disk
Load Bank Load All Presets
XX Bank Name And Sequences
...where “XX” is the bank number and “Name of Bank” is the name of the bank.
Note: The “Name of Bank” is simply the current preset at the time that the bank was
saved. The ENTER light will flash.
FUNCTION BUTTONS
Drive Select
To Next Page
Loading...