Emax II operation manual
51
3. Use the data slider or the increment/decrement buttons to select the bank to be loaded,
then press ENTER. In the case of a floppy disk , simply press ENTER. The display now
says:
Loading Bank...
XX Name of Bank
After several seconds, the disk will be loaded and the display will show the current
preset. If there is a problem with a floppy disk, the ENTER light will flash and the display
will say...
Read Error
Press ENTER to give it another try. Otherwise, try a different disk.
4. To choose a different preset, enter its number with the keypad (see GENERAL
INSTRUCTIONS 1, “Selecting the Current Preset”).
5. To choose which current preset will be active when you load a bank, select the desired
preset just before saving the bank to disk (see PRESET MANAGEMENT 2 , “Save All”).
The Emax II will default to that preset whenever you load the bank.
FUNCTION ENTER DATA
ENTER is something that Emax II, rather than you, activates. Just as you can activate a
module to tell Emax II something you want to do, Emax can activate this module to tell
you something it wants you to do.
Sometimes the display will ask you for data (i.e., such as keying in a number to indicate
a parameter you want to change). A flashing ENTER LED means that either data is
needed to be entered, or another step is involved in completing a function. Under these
conditions, Emax II is in a “holding pattern” where you must enter the desired data, or
de-activate the module, before Emax II can move on to other functions (however, you can
still play the keyboard).
After keying in the data, press ENTER to send the data into Emax II’s computer. If the
ENTER LED is lit steadily, pressing ENTER is optional. Usually this exits you from the
function, and returns you to the module identifier so that you can go directly to another
function within the module.
FUNCTION BUTTONS
Enter Data
To Next Page
Loading...