Emax II operation manual
58
If you don’t want to lose what you have in the bank, save it to disk first (see PRESET
MANAGEMENT 2). Otherwise, press YES.
2. If you booted from a floppy disk, Emax II will ask you to insert the source software
disk. Check that a formatted Emax II disk with the latest software is in the drive. If not,
insert one. To prevent any embarrassing errors, write-protect the disk (GENERAL
INSTRUCTIONS 4). Press ENTER. There will be a short wait while Emax II loads the
formatting software.
If you booted from a hard disk, Emax II will simply load the software into its memory
from the hard disk. In either case, the display will say:
Format Disk
Select a Drive
FORMAT FLOPPY - Select SCSI 0 in order to format a floppy disk, then press ENTER.
FORMAT HARD DISK - If you want to format a hard disk, select the correct SCSI ID
number of the hard disk and press ENTER. When formatting a hard disk, disconnect any
other HDs if possible, to avoid accidently formatting the wrong hard disk. Formatting
a hard disk takes 15-20 minutes, so take a break.
If you are formatting a floppy, the display says:
Pls Insert Disk
To Be Formatted
4. Remove the source disk and insert the disk to be formatted, then press ENTER.
The display will say:
Formatting
Formatting a floppy takes about a minute and a half.
MASTER
Format Disk
To Next Page
Loading...