E-Mu EMAX II - Define Custom; Copy HD to HD

Emax II operation manual
61
■ 0 Define Custom
This function tells the Emax II to save the previous backup function as your custom
backup. When you have chosen your preferred backup scheme, simply execute it once,
then use this function and it will be permanantly saved. The next time you want to
backup, use the Custom Backup function and the procedure will be performed automati-
cally. See also Custom Backup.
■ 1 Copy HD To HD
This function allows the backup of an entire hard disk to another hard disk. The display
shows:
Backup SCSI X
Needs YYMB
... where X is the currently selected SCSI drive and YY is the amount of HD memory (on
the destination drive) needed to back it up.
Press ENTER to continue and the display says:
SCSI X to SCSI _
Use the numeric keypad to enter the destination drive ID number, then press ENTER.
The display will show the amount of memory avaialable on the destination drive in
megabytes, and percentage of memory remaining.
The display now asks:
SCSI X to SCSI Y
Interactive? Y/N
If you select YES (Interactive), you will be asked to confirm the copying of each bank.
If you select NO, the backup will be performed on all banks without user intervention.
MASTER
Backup/Restore