Emax II operation manual
63
The display now says:
Select High Bank
BXX Name of Bank
Select the highest bank to be backed up, then press ENTER. The backup process will
continue.
■
4 Custom Backup
Custom Backup allows you to use a custom backup procedure that you defined using
function O-Define Custom. When you Define Custom, the Emax II simply saves the
previously used backup function as your custom backup. If you backup regularly,
Custom Backup will be your main routine and will save you many keystrokes. As an
example, this is what the screen would show for an automatic backup of selected banks
7-10 from SCSI 1 to SCSI 4.
Backup=07-10Auto
SCSI1->Same# OK?
■
5 Continue Backup
This function is used when backing up to a removable media device or to a series of disks
from a larger disk. If the destination HD become filled and cannot receive the entire
backup, Emax II remembers which banks have not been backed up and allows you to
change the removable media or switch SCSI ID numbers. The Continue Backup function
allows you to continue backing up from where you left off. If a previous backup (which
left any of the banks unsaved) has not been performed, the error message, “Cannot
Continue Backup”, will be displayed.
■
6 Backup to Floppy
This mode is used if you want to backup the entire contents of a HD to floppy disk.
The display shows:
Backup SCSI X
Need YY Floppys
... where X is the cuurently selected HD, and YY is the number of floppy disks needed.
MASTER
Backup/Restore
To Next Page
Loading...