Emax II operation manual
64
After the source drive is selected, you will be prompted as to the number of disks needed
for each bank. Press YES to backup a particular bank, or NO to skip to the next bank.
Save to NN disks
BXX Name of Bank
... where NN is the number of floppy disks required, XX is the bank number, and “Name
of Bank” is the name of the bank.
If YES is selected, the display says:
Takes NN disks
Insert disk 1
Continue to feed Emax II floppy disks as directed until the backup process is complete.
This will take awhile.
■
7 New Banks to Floppy
This function is identical to a normal backup to floppy, except that only banks that have
been changed or added to since the last backup are eligible to be backed up.
■
8 Selected to Floppy
This function allows you to choose a range of banks to be backed up. You select the
starting and ending bank numbers of the banks you want backed up.
■
9 Floppy Restore
This function is simply an automated load and save bank function, which could be used
to restore the HD in the event of a hard disk failure. Insert a backup disk, then press
ENTER. The disk will be loaded and you will be asked to which bank it should be saved.
Choose the destination, and press ENTER. This process is repeated infinitely.
MASTER
Backup/Restore
To Next Page
Loading...