E-Mu EMAX II - Stop Sampling and Change Sample

Emax II operation manual
66
The display now says:
Copy Sftwre from
SCSI X:DriveName
... where X is the SCSI ID number and “DriveName” is the name of the drive.
Use the data slider to select the SCSI drive that you wish to copy from.
2. Insert the Source disk (the one with the new software) in the drive if you are copying
from floppy.
3. Press ENTER to select the source drive. This clears the bank and loads the operating
system software into the Emax II. The display will say “Just A Moment... “.
4. After the software has been loaded, the display says:
Copy Sftwre to
SCSI X:DriveName
... where X is the SCSI ID number and “DriveName” is the name of the drive.
Use the data slider to select the SCSI drive that you wish to copy to.
Insert the destination floppy disk (if applicable) and press ENTER to initiate the transfer.
After copying the software to a floppy, you have the option of copying the software onto
another disk (insert the disk then press YES) or exit back to the module identifier (press
NO).
■ 2 MIDI Master
This contains three functions. Channel (Chan) allows you to set the MIDI channel of the
Emax II and ignore the programmable channels in each preset. Overflow (Ovfl) is used
to turn overflow mode on or off. Overflow mode transmits notes over MIDI only when
the Emax II runs out of channels. HD Load allows you to load a hard disk bank via a
MIDI program change. HD load is set to a preset that is used to tell the Emax II that the
next preset change command will change the hard disk bank number. If an invalid bank
number is sent, the Emax II will return to normal preset mode.
Note: Be careful when using the HD load function to prevent the accidental loading of
seemingly random HD banks.
MASTER
MIDI Master