Emax II operation manual
68
■
5 MIDI Analyzer
The MIDI Analyzer is a useful function designed to help you solve MIDI interconnection
problems.
Select Special 6 and the display says:
MIDI Data: In
Use Data Slider
Moving the data slider changes the analyzer from analyzing MIDI IN to analyzing MIDI
OUT. Press ENTER to select.
The display now says:
Waiting for
MIDI Data
When MIDI data is received (or sent), the data will be displayed. The analyzer
recognizes most MIDI messages, but does not display System Exclusive or Active
Sensing messages.
■
6 SCSI Boot ID
This function allows you to select which SCSI drive (0=floppy, 1-7=HD) Emax II will
scan on initial power up for its operating software. Note: Emax II will always boot from
floppy if a formatted floppy disk resides in the drive on power up.
The display says:
Preferred Boot
Drive: SCSI X
... where “X” is the preferred SCSI ID number.
Use the data slider to select the preferred boot drive, then press ENTER.
Note: You MUST press ENTER in order to store this setting in the Emax II.
MASTER
MIDI Analyzer
To Next Page
Loading...