Emax II operation manual
81
DIGITAL PROCESSING
DIGITAL PROCESSING 0 CHANGE CURRENT VOICE
This function changes the current voice selection.
1. Activate DIGITAL PROCESSING 0. The display says:
Process Pri or
Sec Voice: XXX
...where XXX is either Pri or Sec. Use the data slider to select whether you will edit the
Primary or Secondary voice, then press ENTER. If there are only Primary or Secondary
voices, Emax II will automatically go to step 2.
2. The display now says:
Key: XX YY KHZ
Select a Voice
...where XX defaults to the lowest note of the lowest voice (whether Pri or Sec), and YY
is the sample rate. Press a key in the range of the voice that you want to edit, or to quickly
select the voice, use the data slider or increment buttons. While selecting the voice, the
lower display line will show the voice number and its original pitch. After selecting the
voice to be processed, press ENTER.
3. If the sample to be processed is used in other presets, processing the sample will
process the sample in those other presets. Therefore, the display asks:
Used Elsewhere
CopyItFirst? Y/N
Press NO, and any processing will affect other presets containing that sample. To avoid
affecting other presets containing the sample, press YES to copy the sample—the
current preset will contain the new copy in place of the original sample. Either response
returns the Emax II to the module identifier. If there is “not enough memory” to
duplicate the sample, the display will tell you.
If it is important to copy the sample, erase an unneeded voice (to gain memory space)
(PRESET DEFINITION 3 ) and try again. Note that if a sample is used in other presets,
Change Current Voice
To Next Page
Loading...