Emax Owners Manual
© 1986 E-mu Systems, Inc. Enhanced by The Emulator Archive 2001 Page 106
1. Activate ANALOG PROCESSING 18. The display will say:
...where XX is a two-digit number between 00 and 15.
2. Select the desired parameter for adjustment with the cursor buttons, then use the data slider to
change the parameter value. These are the available parameters:
Atk: Determines the extent to which keyboard velocity controls VCA attack time.
When set to 00, no matter how hard or soft you play the attack time will remain
as set in ANALOG PROCESSING 12, VCA Attack. Increasing the value
causes the attack time to increase as you play more softly. A setting of 15
gives the greatest variation in attack times between hard and soft playing.
FAtk (Filter Attack): Determines the extent to which keyboard velocity controls filter attack time.
When set to 00, no matter how hard or soft you play, the fitter attack time will
remain as set in ANALOG PROCESSING 14, Filter Attack. Increasing the
value causes the fitter attack time to increase as you play more softly. A setting
of 15 gives the greatest variation in attack times between hard and soft playing.
Pan: Determines the extent to which keyboard velocity controls stereo placement.
When set to 00, no matter how hard or soft you play, the panning will remain as
set in ANALOG PROCESSING 19, Panning. Increasing the value causes the
signal to pan in the opposite direction of the current spatial placement; the
higher the value, the greater the difference in stereo spread between soft and
forceful keyboard playing. Example: With the Voice panned slightly to the left
and a high pan velocity value, playing softly leaves the Voice slightly to the left,
which playing forcefully pans the Voice towards the right extreme. In-between
dynamics produce placement in-between the two extremes.
3. After making your selections, press ENTER to return to the Module Identifier.
Module: ANALOG PROCESSING 19 Function: PANNING
This function controls the static stereo placement of a Voice or Voices. The stereo placement may
additionally be modulated via the LFO (ANALOG PROCESSING 16), keyboard dynamics (ANALOG
PROCESSING 18) or real-time controls (PRESET DEFINITION 9).
1. Activate ANALOG PROCESSING 19. The display will say:
...and a marker will appear somewhere in the lower line of the display to indicate current position in
the stereo field. The number in the upper display correlates to stereo position, where -07 is all the
way left and +07 is all the way to the right. +00 indicates center.
2. Use the data slider to vary the stereo placement; moving the marker to the left shifts the sound to the
left, and moving the marker to the right shifts the sound to the right.
3. After making your selections, press ENTER to return to the Module Identifier.
Vel: Atk FAtk Pan
XX XX XX
Panning: +00
L >< R
To Next Page
Loading...