E-Mu ESI-32 - Create Preset

110 ESI-32 Operation Manual
5. If desired, rename the preset. Choose the characters to be changed
with the left and right cursor buttons. Select the desired characters
by using the ten key pad, data entry control and keyboard. You can
also use the up cursor to insert spaces and the down cursor to delete
spaces.
6. Press ENTER to exit the submodule. The ESI-32 will return to the
Module Identifier.
An empty preset must be initialized by the ESI-32 before it can hold
samples. This initialization process is called creating a preset.
1. Activate Preset Management module.
2. Select Submodule 5.
3. Select the preset to be created, then press ENTER. If you try to
overwrite an existing preset, you will be asked if you want to over-
write. Enter Yes to replace the existing preset, or No to cancel the
operation.
CREATE PRESET
P00 Empty Preset
Select a Preset
5. If desired, rename the preset. Choose the characters to be changed
with the left and right cursor buttons. Select the desired characters
by using the ten key pad, data entry knob and keyboard. You can
also use the up cursor to insert spaces and the down cursor to delete
spaces.
6. Press ENTER to exit the submodule. The ESI-32 will return to the
Module Identifier.
5. Create
Preset