E-Mu ESI-32 - Dynamic Processing

Preset Definition 171
Sample 01
Fc
Secondary Samples
Primary Samples
Vel -> Level
Tuning
Pan
Sample 02 Sample 03 Sample 04
Sample 05
Sample 06
Sample 07 Sample 08
= Copied Zone
A copied zone consists of all Samples and Dynamic Processing parameters contained in that zone.
! Caution: If the source zone contains no
secondary samples and you select both,
loading the zone will overwrite both primary
and secondary samples in the destination
preset.
The second line shows the note being played on the keyboard (or
scrolled with the data entry control). After selecting a note, the third line
will display the primary sample number, and the fourth line displays the
secondary sample number associated with the note on line two.
6. Press Yes to erase the zone, or No to cancel the operation. In
either case, you will return to the Module Identifier.
This submodule allows zones to be copied into any preset.
1. Activate Preset Definition module.
2. Select Submodule 4.
3. Select the preset that contains the zone to be copied, then press
ENTER.
COPY ZONE from
P00 Current Preset
Select Source Preset
4. Select whether you will copy the primary, secondary, or both
samples from the zone, then press ENTER.
COPY ZONE from
P00 both
Select pri/sec/both
COPY ZONE from
P00 both C1
Select Low Key
4. Copy
Zone