Appendix 215
Problem: Certain sounds do not play polyphonically.
Cause: The zone may be in solo mode, or only assigned to one
output channel.
Solution: Disable solo mode and check output channel assign-
ment.
Problem: Certain sounds cut off prematurely.
Cause: More than 32 mono, or 16 stereo channels are playing.
Or, if specific output channels are assigned, two sounds
may be “ripping each other off”.
Solution: Check output channel assignment (Dynamic Processing,
9). Try turning Dynamic Allocation (Master/Global, 4)
on. Set release times on VCA to a shorter setting.
Problem: Stereo samples are only heard out of one side.
Cause: Disable side function is turned on.
Solution: Turn disable side function (Dynamic Processing, 1) off
in the zone.
Problem: Audible hum in system when ESI-32 is connected.
Cause: There is a ground loop present in the audio system.
Solution: Find and eliminate the ground loop.
Functional Problems
Problem: Front panel buttons double trigger.
Cause: Buttons need cleaning.
Solution: Consult your dealer or authorized E-mu service center.
Problem: Looping only works while in the Digital Processing
module.
Cause: Disable Loop function is turned on.
Solution: Turn disable loop function (Dynamic Processing,1.
Setup) off in the zone.
Problem: Controllers (wheels, pedal, pressure) do not work at all.
Cause: Controllers are not assigned in the preset.
Solution: Assign the controllers to the desired destinations (Preset
Definition, 0. Realtime Controls).
To Next Page
Loading...
