E-Mu Vintage Keys - Page 169

Vintage Keys Operation Manual 159
Preset Edit Menu
PatchCords
Here is a list of all layer modulation sources and destinations.
Modulation Sources: Modulation Destinations
Off Off
Key (+, +
) KeySust (Key Sustain)
Velocity (+, +
, <) FinePtch (Fine Pitch)
RlsVel (Release Velocity) Pitch
Gate Glide
Pressure (Aftertouch) ChrsAmt (Chorus Amount)
PitchWhl (Pitch Wheel) ‘SStart (Sample Start) -note-on)
ModWhl (Modulation Wheel) SLoop (Sample Loop)
Pedal SRetrig (Sample Retrigger)
MIDI Volume (Controller 7) FiltFreq (Filter Frequency)
MIDI Pan (Controller 10) ‘FiltRes (Filter Resonance -note-on)
MIDI Expression (Controller 11) AmpVol (Amplifier Volume)
MIDI A-P AmpPan (Amplifier Pan)
PLagOut (Preset Lag Out) RTXfade (Real-time Crossfade)
PRampOut (Preset Ramp Out) VEnvRts (Volume Envelope Rates -all)
FootSw1 - 3 (Foot Switch 1-3) VEnvAtk (Volume Envelope Attack)
FootFF (Flip-Flop Foot Switch 1 -3) VEnvDcy (Volume Envelope Decay)
Key Glide VEnvSus (Volume Envelope Sustain)
VolEnv +, +
, < (Volume Envelope) VEnvRls (Volume Envelope Release)
FilEnv +, +
, < (Filter Envelope) FEnvRts (Filter Envelope Rates -all)
AuxEnv +, +
, < (Auxiliary Envelope) FEnvAtk (Filter Envelope Attack)
LFO 1 & 2 (+, +
) FEnvDcy (Filter Envelope Decay)
White (White Noise) FEnvSus (Filter Envelope Sustain)
Pink (Pink Noise) FEnvRls (Filter Envelope Release)
XfdRand (Crossfade Random) FEnvTrig (Filter Envelope Trigger)
KeyRand 1 & 2 (Key Random) AEnvRts (Auxiliary Envelope Rates -all)
Lag 0 sum (summing amp out) AEnvAtk (Auxiliary Envelope Attack)
Lag 1 sum (summing amp out) AEnvDcy (Auxiliary Envelope Decay)
Lag 0 & 1 (Lag Processor) AEnvSus (Auxiliary Envelope Sustain)
Clk Divisors (Octal, Quad, Double
Whole, Whole, Half, Qtr, 8th,16th)
AEnvRls (Auxiliary Envelope Release)
DC (DC Offset) AEnvTrig (Auxiliary Envelope Trigger)
Summing Amp LFO 1 & 2 Rate
Switch LFO 1 & 2 Trigger
Absolute Value Lag Processor In 0 & 1
Diode Sum (Summing Amp)
Flip-Flop Switch
Quantizer Abs (Absolute Value)
4x Gain Diode
Quantize
Flip-Flop
Gain 4x
Cord 1-24 Amount
Note: Flip-Flop Footswitches
1 & 2 remain in their last
condition when a new preset
is selected.
Flip-Flop Footswitch 3 resets
to the Off condition whenever
a new preset is selected.
Note: The Envelope Sustain
parameter controls the Decay 2
Level segment of the envelope
generator.