Xtreme Lead-1 Operation Manual 37
Basic Operations
Front Panel Controller Modes
When you turn a knob, the field value jumps to the current knob value.
You can still use the Data Entry Control for editing by moving the cursor to
the desired field.
To move through menus horizontally, use the Data Entry Control (the
page’s title field is the default cursor position). To move through menus
vertically (preset layers), press the left cursor to get to the layer field, then
change layers with the Data Entry Control.
• Use the Data Entry Control to move through menus (horizontally) or
layers (vertically).
• Use the Controller Knobs to change parameter values within each page.
L1
KEY: LO FADE HIGH FADE
C-2 000 G8 000
A/ E / IA/ E / I B/ F / JB / F / J C/ G / KC/ G / K D/ H / LD / H / L
To Next Page
Loading...
