SAFETY
Page B-9
Repair and Service Manual
Read all of Section A and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings
To raise the entire vehicle, install chocks in front and
behind each front wheel (Ref Fig. 3 on page B-8). Center
jack under the rear frame crossmember. Raise vehicle
and locate a jack stand under outer ends of rear axle.
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack at the center of the front axle. Raise the
vehicle and position jack stands under the inner frame
member as indicated.
Lower the jack and test the stability of the vehicle on the
four jack stands.
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised in order to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence
To Next Page
Loading...
Need help?
General
