8/8/2005 Page 1 of 7
© 2005 GLOBAL VR, INC. All Rights Reserved. Electronic Arts, EA, and EA SPORTS are trademarks or registered trademarks of Electronic Arts Inc. in the U.S. and/or other
countries. All rights reserved. PGA TOUR is a trademark of PGA TOUR, INC. and used by permission. Global VR is a registered trademark of Global VR, Inc. All other
trademarks are the properties of their respective owners.
Installing the Externally Mounted Players' Card Dispenser on
EA SPORTS™ PGA TOUR
®
Golf Challenge Edition Upgrade Cabinets
Document Part #: 040-0074-01
This document describes how to install the externally mounted Players' Card dispenser.
GLOBAL VR
®
also offers an internally mounted dispenser (part # 90538-00), which is installed by
cutting an opening in the front of the cabinet.
Kit Contents for Part # 90541-00
Part # Description Part # Description
NA Players' Card Dispenser
Assembly with Vault
4600-0012 Wood Screws (3)
115-0003-01 DB25 Ribbon Cable 100-0021-01 Cable Ties (2)
4600-0062 DB Mounting Posts (2) PLC1.5IS8-C Screw-Mounted Cable Tie
USBIO Nytric Version 1.5 USBI/O Card
(or USBI/O Extreme Card)
NA 1/4-20 x 1-1/4” Bolts with Nuts and
Washers (4)
115-0074-01 Players' Card Dispenser Harness 52-6212-00 Button Plugs (2)
44-1100-01 +5/+12 VDC Power Supply* 040-0074-01 Installation Instructions (This Document)
115-0008-01 AC Power Harness* 3100-0001 Players' Cards (25)
115-0079-01 DC Power Harness* Pre-paid UPS Mailing Label for Returning
the USBI/O Card to GLOBAL VR
®
(for
Domestic Use Only)
*Power supply and associated harnesses are not required for Canadian cabinets.
Tools Required
• Nutdriver or Wrench
• Phillips Screwdriver
• Drill
• 1/4" and 3/4" Drill Bits
• Pencil
To Next Page
Need help?
General
