Blade Holder 3pcs
1. Turn off power before assembly & disassembly. To avoid electrical shock,
connect earth / ground wire first, followed by neutral wire and active wire last.
For disassembly, disconnect active wire first, followed by neutral wire and
ground / earth wire last.
2. Ensure that all screws are tight throughout the course of installation.
3. Ensure that blades are not obstructed by other objects and are able to turn freely.
4. The electrical supply must include an isolation switch providing at least 3mm
contact separation on all live conductors.
6. Ceiling fan must be mounted at a min. distance of 2.1m clearance from floor
and 1.5m from wall to blade. Needs to comply with AS/NZS 60335.1 and
AS/NZS 60335.2.80
7. Do not install at areas / place near / at
a) chemicals and alkali
b) flammable area such as gas cooker
c) oily places
d) wet and high humidty area such as shower room
e) high vibration / impact and continuously expose to direct wind
8. Do not place any objects in the path of the blades
9. When all electrical connections are done, store all wires neatly.
10. Make sure that are screws are tight prior to switching on fan.
this product. Please engage a licensed electrician to carry out installation
and / or undertake any servicing.
10. Trouble shooting
6. Attaching an accessory light kit
To Next Page
Loading...