OPERATOR INSTRUCTIONS AND PARTS
CRT Models 6014V
Page 23
800-345-6007
CRT MOTOR MOUNT PARTS LIST
REF. NO. PART # DESCRIPTION QTY.
1 810 BOLT, 5/16-24 X 1 HH GR5 2
2 504 LOCKWASHER, R-SPRING 5/16” 9
3 WF516 WASHER, FLAT 5/16” STANDARD ZN 12
4 53649 GUARD, BELT REAR TINE 12/05 1
5 53638 RIVET, PLASTIC PUSH IN REAR TINE, 12/05 1
6 1407 SPRING FORWARD ARM 1
7 803 WASHER, 5/16”ID X 1-1/2”OD FLAT 16 GA. 2
8 53730 BOLT, 5/16-18 X 2-1/2 HH GR5 ZN 4
9 31315 BELT, DRIVE L4 POWER RATED 1
10 3178 PULLEY, SINGLE GROOVE ENGINE 1
11 802 BOLT, 5/16-24 X 3/4 HH GR5 ZN 3
12 53622 WELDMENT, CABLE PULL PLATE RT, 12/05 1
13 742 SPACER, DRIVE PULLEY .550” 1
14a 31320 ENGINE, 6.5 HP VIPER HORZ 1
14b 3364 KEY 1
15 1501 BOLT, 5/16-18 X 3/4 SFHH GR5 ZN 13
16 53618 CLIP, BELT GUARD TILLERS, 12/05 2
17 8655 BOLT, 5/16-18 X 1-3/4 HH 4
18 31306 TAB, BELT GUARD SUPPORT SMALL REARTINE 1
19 60G5NY NUT, 5/16-18 NYLOC 10
20 482508 BOLT, 1/4-20 X 1-3/4 HHCS GR5 BLK ZN 1
21 48261B WASHER, 1/4 BLK ZNC 6
22 53633 GUIDE, BELT REAR TINE 12/05 1
23 67538 NUT, 1/4-20 HNYLK ZN 5
24 48240 BOLT, 1/4-20 X 1-1/2 HHCS GR5 ZN 4
25 31302 PAN, LOWER 1
26 31301 PLATE, TRANNY COVER/HOOD MOUNT 1
27 53413 DIPSTICK 1
28 31305 WELDMENT, ENGINE/HANDLE MOUNT 1
29 1662 NUT, 3/8-16 NYLOCK 4
30 WF38 WASHER, FLAT 3/8 STANDARD ZINC 4
31 48144B BOLT, 3/8-16 X 2 HHCS GR5 ZN 1
32 53596B YOKE, ZINC PLATED CLEVIS 1
33 53617 ARM, FORWARD REAR TINE, 12/05 1
34 1416 PIN CLEVIS 1
35 1408 PULLEY, IDLER FORWARD 1
36 2104 NUT, 3/8-16 HLKBW ZN 3
37 53637 BUSHING, FORWARD ARM REAR TINE, 12/05 1
38 739 BELT GUIDE, REVERSE 1
To Next Page
Loading...
Need help?
General
