Why does my EarthQuake Lawn and Garden Equipment engine miss or lack power?
If your EarthQuake Lawn and Garden Equipment engine misses or lacks power: * Remove and clean the gas tank if it's clogged. * Clean or replace the air filter if it's clogged. * The carburetor may be out of adjustment; please call factory. * Clean, replace, or gap the spark plug if it's wet, faulty, or improperly gapped.
What to do if EarthQuake E43 earth auger powerhead Lawn and Garden Equipment auger turns, but has no power?
If the auger on your EarthQuake Lawn and Garden Equipment turns but has no power: * Turn off the choke after the engine is running. * The carburetor may need adjustment; please call factory. * The transmission may be broken; please call factory. * Replace worn clutch shoes and spring. * The engine lower seat may be worn; please call factory.
How to start my EarthQuake Lawn and Garden Equipment if the engine won't start?
If your EarthQuake Lawn and Garden Equipment engine won't start, check the following: * Ensure the power switch is in the 'on' position. * Verify the spark plug wire is connected to the spark plug. * Make sure the unit has fuel. * Inspect the spark plug; clean, replace, or gap it if needed. * Squeeze the throttle control while pulling the recoil handle. * Ensure the fuel line hose is positioned at the bottom of the gas tank.
Why is my EarthQuake E43 earth auger powerhead Lawn and Garden Equipment engine hard to start?
If your EarthQuake Lawn and Garden Equipment engine is hard to start: * Drain any stale fuel and replace it with fresh fuel, consider using a gas stabilizer. * Ensure the spark plug wire is securely attached to the spark plug. * Clean the carburetor, use gas stabilizer, and a new gas can. * Prime the unit 3 more times and squeeze the throttle while pulling the recoil handle.
What to do if EarthQuake E43 earth auger powerhead engine runs rough and floods?
If the EarthQuake Lawn and Garden Equipment engine runs rough or floods during operation: * Clean or replace the air filter. * Turn off the choke. * The carburetor may need adjustment; please call factory.
Why does my EarthQuake Lawn and Garden Equipment engine run, then quit?
If your EarthQuake Lawn and Garden Equipment engine starts but then quits: * Open the manual venting gas cap screw all the way open (counterclockwise). * Clean or replace the fuel filter if it's plugged. * The carburetor may be out of adjustment; please call factory.
Why does my EarthQuake E43 earth auger powerhead Lawn and Garden Equipment engine rev too high?
If your EarthQuake Lawn and Garden Equipment engine revs too high, the carburetor may be out of adjustment. Please call factory.
Why does my EarthQuake E43 earth auger powerhead Lawn and Garden Equipment auger cut slowly?
If the auger on your EarthQuake Lawn and Garden Equipment cuts slowly: * Replace the dull blade or have it sharpened at the factory. * Replace the damaged fishtail point.
Why does EarthQuake E43 earth auger powerhead Lawn and Garden Equipment auger turn at idle?
If the auger on your EarthQuake Lawn and Garden Equipment turns at idle: * Adjust the idle speed lower. * Replace the broken clutch spring.
What causes EarthQuake E43 earth auger powerhead Lawn and Garden Equipment auger to jump?
If the auger on your EarthQuake Lawn and Garden Equipment jumps, the blade may be damaged. Replace it with a new blade.
General| Engine Displacement | 43cc |
|---|---|
| Weight | 22 lbs |
| Starting System | Recoil |
| Fuel Mix Ratio | 40:1 |
| Engine Type | 2-Cycle |
| Auger Bit Compatibility | Earthquake Auger Bits |
Outlines the owner's duty for accurate assembly, safe use, and proper maintenance of the powerhead.
Detailed safety instructions for operating the auger, emphasizing hazard awareness and correct procedures.
Highlights important safety concerns, machine damage warnings, and helpful operational information.
Details the dangers of carbon monoxide from engine exhaust and symptoms of poisoning.
Explains the flammability of fuel and vapors, and precautions to prevent fires and explosions.
Advises on avoiding contact with hot engine components and keeping flammable materials away.
Procedure for safely performing maintenance or repairs on the engine or auger.
Ensures correct throttle cable seating, and recommends specific oil and fuel for optimal performance.
Step-by-step guide for properly mixing fuel and oil in a safe, well-ventilated area.
Detailed steps for safely filling the gas tank, including cooling the engine and proper ventilation.
Guidance on clutch break-in, auger efficiency, safe practices, and operating the manual venting gas cap.
Detailed procedure for starting the engine when it is cold or has run out of fuel.
Steps to start the engine when it is warm, following cold start procedures if needed.
Procedure for starting the engine when it is already hot from recent use.
Lists dangerous methods to avoid when attempting to start the engine to prevent damage or injury.
Maintenance tasks for the gear case and general tightening of bolts and nuts for the power auger.
Emphasizes engine maintenance importance and provides a schedule for routine tasks.
Guidance on cleaning and servicing the air filter, including specific steps for ring-style foam filters.
Detailed procedure for cleaning the block-style foam air filter, including removal, cleaning, and reinstallation.
Details on the recommended spark plug, its maintenance, and replacement criteria.
Guidelines for safely transporting the earth auger, emphasizing fuel safety and ventilation.
Procedure for preparing the earth auger for extended storage, including fuel stabilization and greasing.
Information on troubleshooting common problems and contacting Ardisam for service or repairs.
Details on how to order replacement parts from the manufacturer, including required information.
Diagram illustrating the various parts of the E43 Powerhead and Auger assembly.
A detailed list of all parts for the E43 Powerhead, including part numbers and quantities.
A comprehensive list of auger parts and accessories, with their respective part numbers and quantities.
Exploded view diagram identifying the individual parts of the E43 engine.
Diagram showing the components of the air filter block style assembly.
A detailed list of E43 engine parts, including part numbers, descriptions, and quantities.
Details the 1-year limited warranty for the Earth Auger Powerhead, covering defects in material and workmanship.
Outlines the 2-year limited warranty for Viper Engines used in the powerhead, covering materials and workmanship.
Explains the EPA emissions control warranty provisions and covered components for Viper Engines.
Specifies owner responsibilities for maintenance to maintain warranty validity and requirements for repairs.
Lists conditions and actions that will void the emissions control systems warranty coverage.
Formal declaration of the product's conformity with European Union noise directives.
Certification of compliance with relevant EU directives, including machinery and noise regulations.
To Next Page
