Why does my EASTMAN Industrial Equipment motor overheat?
Your EASTMAN Industrial Equipment motor may be overheating due to several reasons. First, the cut out switch might not be engaging properly, so ensure it is correctly engaged. Second, there may be lint and dust inside the motor cover, so clean it out. Lastly, if it is a three-phase system, check if each phase is working.
General| Brand | EASTMAN |
|---|---|
| Model | Blue streak II 629X |
| Category | Accessories |
| Language | English |
Defines terms Warning, Caution, and Note for safety alerts.
Steps for running the machine safely.
Steps for sharpening the machine's knife.
Step-by-step guide for replacing the machine's knife.
Instructions for adjusting Bevel Bloc sharpener shoes for knife bevel.
Detailed steps for adjusting bevel on knife edge for different lengths.
Common problems and their solutions for the machine.
Guide to ordering replacement parts for the machine.
Part numbers for single-phase motor assemblies.
Part numbers for three-phase motor assemblies.
Part numbers for the front bearing housing and oiler assembly.
Part numbers for the front view of the sharpener housing.
Wiring diagrams and connections for different voltages and phases.
To Next Page
