EASTONTECH EW Series - Speed and Output Settings

EW-ECO SERIES OPERATION MANUAL
12
0the larger of the knife retreat value should be; Parameter setting press
flashes forward a paremeter; press after the removal of a
blinking parameters; at any time by withdraw from the set of
parameters, back to the standby state;
Stripping speed settings: The machine when in standby mode press
; cutter speed parameter started flashing at this time can directly
enter the number, if the input error, press clear input digital input
again; Then press preservation, and a parameter flicker, until the
cutting speed, feeding speed, stripping speed, pause time all input to
comlete; Parameter setting; press flashes forward a parameter;
press after the removal of a blinking parameters; at any time by
withdraw from the set of parameters, back to the standby state;
Output settings: The machine when in standby mode press ;
gross parameter set to begin to flicker, at this time can directly enter the
number, if the input error, press clear input digital input again;
Then press preservation, and a parameter flicker, until the set, the