EASTONTECH EW Series - Twisting and Program Settings

EW-ECO SERIES OPERATION MANUAL
13
total number of all input to comlete; Parameter setting; press
flashes forward a parameter; press after the removal of a
blinking parameters; at any time by withdraw from the set of
parameters, back to the standby state;
Twisted line set: The machine when in standby mode press ;
Front twist mode scintillation, this time press 、 switching,
Then press preservation, and a parameter flicker, until the front
twist, twist wire mode input mode is completed, then by previous
methods input torsion line speed, twisting strength; Parameter setting;
press flashes forward a parameter; press after the
removal of a blinking parameters; at any time by withdraw from
the set of parameters, back to the standby state;
Program number set: The machine when in standby mode, press
; program arguments begin to flicker, at this time can directly enter
the number, if the input error, press clear input digital input again;
then press preservation, to standby state;