EASTONTECH EW Series - Stripping Parameter Precautions

EW-ECO SERIES OPERATION MANUAL
19
Parameter setting: press start settings, until all parameters input
to complete;
Stripping set matters needing attention
1
、
a number of stripping parameter, total length must be greater than the
front end length + back-end length; otherwise the work machine;
2
、
the use of communication control of the machine, must ensure that the
machine in the display screen work and non parameter etup state;
otherwise, the communication control is invalid;
3
、
use the appropriate speed operation;
4
、
in the screen work and non parameter settings, Can be directly press