EW-ECO SERIES OPERATION MANUAL
、 the cutter set value without stopping;
5
、
if the four running indicator light flashes, illustrates the setting
parameters, can start the machine;
6
、
twisting line setting: the first torsional offset paremeters is designed for
short-term twisting function set, meaning when the machine off your
front, wire feeding after twisting wheel distance; sometimes can be
fitted to the short-term blade after twisting wheel, then the parameter
set small, reach short-term torsion a line function; general line is set to
32, no need to change; short-term according to the blade and the wire
twisting wheel actual distance adjustment; ( can single-step operation
mode to the step, if the wire feeding more than wire twisting wheel,
can reduce the parameter can be increeased, and vice versa;)
Six, Introduction of communication protocol
The machine is equipped with a standard RS485 communication
function, the user can through the host computer ( PLC, PC ) to directly
control the machine; communication hardware specifications for 38400, 8,
1, N
The following is the machine accepts commands in detail
1
、
the emergency stop command: PC issued three byte hexadecimal
number 16 01, 66, 99; wherein the first 01 is the station number, can
set up a system screen to change, the machine successfully received
To Next Page
Loading...