EASTONTECH EW Series - Troubleshooting Common Issues; Stripping and Cutting Failures; Wire Skin and Length Problems

EW-ECO SERIES OPERATION MANUAL
26
Eight, Phenomenon and exclusion
The emergence of the
phenomenon
Processing method
Thread stripping without
1、check the thread cutting depth, cutting marks too shallow for regulating
“ diameter ” smaller.
2、 the line wheel pressure is not enough, need to adjust the “ into the line
wheel pressure regulating knob ”, the line wheel pressure.
3 、 the line wheel clearance is too large, need to adjust the “ into the line
wheel clearance adjustment knob ”, the line wheel clearnce is reduced to
a proper position.
4、stripping the first set is greater than or equal to 3.
5、the line wheel if there is dirt, required to be cleaned.
6 、 retreat knife set may be too large, should be appropriate to reduce the
retracting parameter ( reference value 00-10 ).
7、the next tool misalignment, please refer to chapter seventh section 2 test
chart 7-7 alignment condition.
Wire stripping without tail
1 、 check line tail cutting depth, cutting marks too shallow for regulating
“ diameter ” smaller.
2、wire wheel, the pressure is not enough, need to adjust the “ round round
pressure regulating knob ”, the line wheel pressure.
3、wire wheel clearance is too large, is required for the regulation of “ round
round gap adjustment knob ”, make the pulley gap is reduced to a proper
position.
4、stripping the first set is greater than or equal to 3.
5、pulley if there is dirt, required to be cleaned.
6 、 retreat knife set may be too large, should be appropriate to reduce the
retracting parameter ( reference value 00-10 ).
7、the next tool misalignment, please refer to chapter seventh section 2 test
chart 7-7 alignment condition.
Wire skin of severe
barotrauma
1、first judge barotrauma from inlet wheel or pulley, wheel pressing force to
be small.
2、contact with my company, the purchase of rubber tire.
Thrum peel line core cut of
several root
The “ diameter ” tone in 1 or 2, retry until notto hurt the line core.
Length of line, there is
greater than or equal to the
set length
1 、 the line wheel pressure is not enough, and sometimes thread stripping
without phenomenon, thread stripping on line is greater than a
predetermined length, regulating “ into the line wheel pressure regulating
knio ”, so the line wheel pressure.
2、dirt, pulley, required to be cleaned.
A wire inlet wheel clearance is too large, to adjust the “ into the line wheel
clearance adjustment knob ”, and a wire feeding wheel gap smaller.